How do I fit my neon sign?

You have various options on how to install your new LED Neon sign.

If the light is going on a flat surface wall with no foliage behind then you can simply use the provided screws + caps. Or for a professional finish: 30 mm Standoffs (the sign will need 8 mm pre drilled holes)

If you have a foliage plant wall behind- you can use zip ties. Longer screws + screw caps (advise around 70-90 mm screws) or for a professional finish: 60 – 80 mm Standoffs (the sign will need 8 mm pre drilled holes)  to allow the foliage to sit behind the sign naturally.

Unless upgraded- most of our neon signs are sent with pre drilled 2.5 mm holes to allow for zip ties or screws. Please upgrade to standoffs for this finish and to prevent a mixture of hole sizes. if in doubt- please make contact 😊

More advise: 

Zip ties: A really basic and easy way would be to use strong zip ties to hold in place. Simply secure to the netting or a hook. There are usually fixing points in the Perspex that will allow for this. If not drill small holes and link up. Only drill into segments of the Perspex that have a decent coverage. Never near an edge. All our in stock and exclusive ranges come with Zip ties that are green to blend in.

Standoffs: For a more professional finish stainless steel standoff spacers are advised. You may need someone who has a good DIY skill set. Ensure the spacers allow for any wall covering (like our wall panels) to ensure the sign/ board is clear. You need 8 mm pre drilled holes to allow for the 12 mm x 30/60/80 mm standoff fixtures.

Suction cups: great for doors/glass surfaces – however we advise securing the wire in case the suction failed without warning.

Celling wire hook kits: hang from a ceiling or surface to suspend the signage in air.

Please see our full range of neon fixtures and fittings: Click Here